These brushes are good for removing paint and finish out of detailed areas and grain once it is softened by the stripper.

These economical brushes work well for applying stripper, stain, and other chemicals. Typically not good for applying finishes. They come in 5 sizes.

Instead of brushing on the stripper by hand, the flow-over system pumps liquid stripper to a scrub brush fitted at the end of a hose. The scrubbing action of the brush in conjunction with the lifting action of the stripper significantly increase stripping productivity. Stripping time is cut by over 70% over hand stripping with no damage to glue joints, no grain raising, nor lifting of veneers. To strip a chair for example, takes less than ten minutes with a flow-over system compared to at least one hour by hand. Besides being highly productive, is is also cost effective. While stripping, excess remover is filtered, collected in a reservoir, then re-circulated through the pumping system thus minimizing waste. Once the furniture is stripped, it is then power rinsed with a fine spray of cold water or neutralized with a wash thinner, lacquer thinner, or other suitable solvent. Once it is dry, it is then ready to sand and refinish.

Flow-over Tray
(Call in Order Only)

The 4'x 8' is constructed of 14 gauge galvanized steel to prevent rusting when cleaned. Welded seams guarantee a leak proof tray. A 1 1/2" drain is provided at one end on center. Sides are 12" high with a 1" bend at the top to form a frame for damage protection of furniture. Legs are sold separately.

Model 32070 4'x8' Wt. 150 Pounds: $895.00

Leg package - $100.00

Please Note: 10% Discount over $50.00 does not apply to this item.

Explosion proof pumping system that needs no electric motor or electric supply to drive the pump. This self priming, leak proof air driven diaphragm pump requires only 4 CFM at 40 PSI to pump three gallons of remover per minute. Requires a minimum of three gallons of stripper to operate it. and any shop air compressor down to 3/4 HP is sufficient enough to feed air to the pump. An air valve adjusts liquid flow from 0 to 10 GPM. Polypropylene housing Teflon interiors allows the pump to handle all kinds of paint removers from liquids to semi-paste. System includes pump, air valve, chemical tubing, 3/8" ID connected to the stripping brush, brass foot valve and strainer all mounted to a steel base ready to go. 

Complete Pumping System, 32076 - 30 pounds  $595.00

Pump Only 32079 - 10 pounds   $495.00 

"Package Deal on 4'x 8' tray and pumping system."

$1490.00

Buy the two together, and we will throw in the leg package, a pair of stripping gloves, rubber apron, eye goggles, arm protectors, vapor respirator, and a face shield.

A savings of over $150.00 when ordered as a package